Little giant pump vcma-15uls manual

This equipment should be installed and serviced by technically. Know the product's application, limitations, and potential haz-.

Read and follow instructions carefully to avoid injury and. Do not disassemble or repair unit unless. Refer to product data plate s for additional precautions, operat-. Failure to follow installation or operation procedures and all. Do not use to pump flammable or explosive fluids such as. Do not use in explosive atmospheres or hazardous loca-. Do not handle a pump or pump motor with wet hands or.

When a pump is in its application, do not touch the motor,. If the power disconnect is out of sight, lock it in the open. If the disconnect panel is not accessible, contact the elec-.

Previous Page. Next Page. Remove tank cover assembly from the tank. Place a finger in one of the larger holes in the corner of the top and lift to remove the top part of the pump. Connect pump to a dedicated GFCI circuit. Circuit breaker off or fuse removed. Turn on circuit breaker or replace fuse. Accumulation of debris or build-up on float. Clean float; a dirty float could be too heavy to operate correctly.

Pump does not start when tank is full of condensate Remove the tank. Quite el conjunto de la cubierta del tanque. Conecte la bomba a un circuito GFCI dedicado. Disyuntor apagado o sin fusible.

It replaces original equipment pumps in most systems or serves as an enhancement for units requiring manual draining of condensate. In basement installations, the unit is sufficiently powerful to pump water vertically to reach ground-level drain plumbing and drains. Make sure sufficient condensate from the coils of the air conditioner or furnace is reaching the tank to activate the float switch. Check for kinks or obstructions in the inlet tube and make sure inlet tube is adequately sloped to allow gravity feed from the condenser coils.

The motor should turn on just before the float contacts the cover assembly. Lower the motor switch float. The motor should turn off before the float reaches the end of its downward travel. Raise the safety switch float.