Prg 1000 manual guide

Voltage Ripple Noise 0. Height H 88mm Nom. Depth D Weight Please refer to the technical data for detailed specifications and conditions. PDF file of this page Contact Inventory information does not exist. Customers who viewed this product also viewed. Sales Region Worldwide except Japan.

Please refer to here. This page only shows representative characteristics. Technical Support Tools. GEN 7. Images are for reference only and show example products. Voltage Ripple Noise 0. Height H Depth D mm Nom. Weight 44kg Typ. Please refer to the technical data for detailed specifications and conditions. PDF file of this page Contact Inventory information does not exist.

Customers who viewed this product also viewed. Illumination ………………………………………………………………………………………………… E To turn on illumination manually …………………………………………………………………… E To change the illumination duration ……………………………………………………………… E To turn the auto light switch on and off …………………………………………………………… E Other Settings ……………………………………………………………………………………………… E To turn the button operation tone on and off ……………………………………………………… E To turn Power Saving on or off …………………………………………………………………… E Troubleshooting …………………………………………………………………………………………… E The face of the watch is a solar panel that generates power from light.

The generated power charges a. The watch charges whenever it is exposed. Leaving the watch in bright light for charging can cause it to become quite hot. Take care when handling the watch to avoid burn injury. The watch can become particularly hot.

Direct links to the videos are also provided throughout this manual, where applicable. Contact information for all PRG office locations can be found on our website at: www. For additional resources and documentation, please visit our website at: www. It can be used to configure and control all aspects of the MBOX media content and playback, therefore eliminating the need for a lighting console. PowerPCbased Mac computers are not supported.

A Fixture is abstract, and can refer to either the "Server," the "Master" controls for the server, or an individual "Layer. A Server is also a collection of sub-fixtures, the "Master" fixture, plus one or more "Layer" fixtures. Follow instructions to accept license and choose destination.

It is recommended that Director be installed. Step 2. This setting is located in the Network section of the Setup tab as shown below:. This software is required on all MBOX servers to enable remote feedback.

A network switch can be used if multiple MBOX servers need to be connected as shown below:. For troubleshooting assistance while setting up or reconfiguring your network settings, refer to "Troubleshooting" on page In order to guarantee this, MBOX Director can sacrifice the amount of time it spends drawing on its own graphical user interface.

Refer to "General Preferences" on page Step 3. At Network window, select Mbox Extreme as Location and select Ethernet 1 in left column as shown below:. Step 4. Also, set Single Output. Confirm that MBOX. It should update automatically. Step 9. Proceed to "Adding Fixtures" on page Set Configure IPv4 to Manually. These will typically be an IP Address format of 2. Observe the following guidelines:.

Click Apply button to apply network settings. The network administrator should also verify that the subnet mask will allow the two machines to "see" each other. Step 6. Step At Mac computer, connect other end of Ethernet cable to Ethernet 1 port. Step 1. If no servers are connected, the button will be flashing. If the network settings are configured properly, the servers will appear in this list. At Name field, enter custom name if desired.

The name can be edited after the fixture has been created. If connecting to multiple MBOX servers, repeat steps until all servers have been added. When finished,. The main window will now reflect the added fixture s. The MBOX software can use either one or two video outputs. Dual output modes can be enabled by choosing one of the dual DMX Profile options:. When this occurs, the MBOX system will no longer function correctly.

To correct this, use the Change Configuration window refer to the steps on the following page.